How many of us are gamblers?

Welcome to the internet's gathering place for Purple Martin enthusiasts
Louise Chambers
Site Admin
Posts: 6208
Joined: Tue Nov 04, 2003 1:07 pm
Location: Corpus Christi, TX

I don't mean playing games of chance :wink: for money, but I do mean playing games of chance with mother nature, with our martins as 'chips'. Knowing we need to get a predator guard up, but putting it off week after week, hoping we'll slide through the season without any problems... I've done that at my old place in PA - never got around to installing a guard below the tree swallows' gourd. Got away with it, too, but it sure made me nervous. I didn't always win, though - I will never forget the year I went to check on nestbox with baby wrens and looked inside to see scales instead of feathers :cry:

So, if you too are a gambler, here's a reminder to get those pole guards on, it doesn't take that long. Buy them or make your own, but get something up under each nestbox or system.

Here's an article on the basics:

http://purplemartin.org/update/13(1)PoleGuards.pdf

While you're at it, this is a very good time to inspect and replace any ropes, cables, or other equipment that is showing signs of wear & tear.

Louise
Last edited by Louise Chambers on Wed Feb 27, 2008 2:50 pm, edited 1 time in total.
klcretired
Posts: 2174
Joined: Tue Nov 18, 2003 3:06 am
Location: Grand Prairie,Tx

Well put Louise, well put...Thank you so much for reminding everyone how important a predator guard and snake guard is, you wouldn't drive your car without Gas would you???.....well putting up housing/gourds with out protection is just like driving on empty......it will happen just that fast, and then it's too late...your martin year will come to an end....... tragically.
I don't want that to happen to anyone so please, please do something now for the sake of the Martins, their eggs and their Babies.
Pictures Taken with Canon Rebel XT Digital using a Sigma 50-500 Long Lens.

Wishing everyone a Great Martin Year
Happy Martining for 2022 to everyone,

K.C.

[email protected]
Louise Chambers
Site Admin
Posts: 6208
Joined: Tue Nov 04, 2003 1:07 pm
Location: Corpus Christi, TX

Kenny,

You reminded me of something else I wanted to give a heads-up on. Install and USE a safety bolt on all your systems - it could save you if a cable breaks, or your hand slips off a winch handle, etc. Safety bolts must be installed your head height to be effective - drill through the pole to install one if your system doesn't have one. When raising/lowering your system, leave the bolt in place until the housing is just above the bolt - remove and finish lowering. Raising up follow the reverse. As soon as the system is above the hole for safety bolt, reinstall it. Here's a link to safety article with photo of safety bolt:

http://purplemartin.org/update/13(4)Safety.pdf

I'm not sure if anyone has a good external safety clamp in use, that does not require drilling a hole through martin pole. If you do, please share.

Louise
Guest

AMEN Louise,

I kept putting it off last year and lost almost my whole house full of babys to a snake and was almost bitten before I realised he was there. Not this year. I got my stuff in order.


Waiting impatiently in Checotah, :grin: :roll:
Donnie Hurdt MN
Posts: 1723
Joined: Sun Feb 15, 2004 11:14 pm
Location: North Prairie, MN

I have no gaurds on my poles because I have no martins as of yet. BUT the gaurds are ready to put on the poles of whatever housing the martins choose whenever I get martins.
I just feel that they are not necessary if there is nothing to protect.
PMCA member and Martin fanatic....
2011 A pair of subbies fledged three young but none returned in 2012 :-(
2015 One Pair of subbies came and stayed a few nits but got chased away by Bluebirds and Tree swallows. :-(
2017 0ne pair of subbies nested and fledged 4 young
2018 Tree Swallows AGAIN chased away any martins that wanted to nest :evil:
2019 Same old story................ :-(
Al Denton
Posts: 1468
Joined: Tue Nov 11, 2003 7:31 pm
Location: Carolina Shores NC
Martin Colony History: New site and housing for 2018...Trendsetter 12. 1 pair of subs. Fledged 5...2019...11 pairs

I need to install a safety bolt or device. I remove my cable and winch and hardware for winter. I inspect everything too when it goes back up in the spring, but unexpected things can happen. I should get to work on that :oops:
2018-new site...1 pair
2019-11 pairs
2020-15 pairs
James Strickland FL
Posts: 2249
Joined: Thu Nov 13, 2003 8:04 pm
Location: Reidsville NC
Martin Colony History: 2017 Had a lot visitors no Matins nesting, hoping 2018 will be different.
2018 Had 1 pair
2019 had 30 pair

I never gamble when It comes to my martins or my life. I don't get that many martins and everyone of them are important to me as also my life.
ldybala
Posts: 61
Joined: Tue Feb 17, 2004 1:32 pm
Location: Texas/Houston

I use a hose clamp around a bicycle inner tube that has been wound around the pole several times to make the diameter much larger as my safety bolt. I loosen the clamp and slide it down when I lower the pole.
marshainpuntagorda
Posts: 177
Joined: Mon Jan 12, 2004 7:58 pm
Location: Punta Gorda/Florida

I cannot agree more with Louise and other landlords that have written about predator control. I thought I would never have Martins again after a red rat snake ate all the babies in one of the supergourds we had up a few years ago. It was a heartbreaking experience; although we were upset we didn't kill the snake but, carried it for a long ride away, (in a nice tall garbage can!)
I have written posts along with posting pictures showing the snakes caught in the netting ABOVE the stovepipe guard...I also have owl/hawk guards on the supergourds and have credited them with saving many of adults and babies...Good Luck everyone and please for the Martins sake, get those guards up!
Marsha
Think Purple!
Guest

Here are some pictures of a snake that was trying to eat my baby barn swallows that nest every year under my front porch. I will say it is really creepy to look up and see one over you head !!

ging ;)
Attachments
Look what happens when you look up :)
Look what happens when you look up :)
snakeonceling.jpg (36.14 KiB) Viewed 8509 times
catch and release !
catch and release !
caughtsnake.jpg (36.47 KiB) Viewed 8373 times
So cute !!
So cute !!
babybarns.jpg (77.4 KiB) Viewed 8398 times
Donnie Hurdt MN
Posts: 1723
Joined: Sun Feb 15, 2004 11:14 pm
Location: North Prairie, MN

That last photo is amazing. Nothing is safe from those snakes withought protection of some kind.
PMCA member and Martin fanatic....
2011 A pair of subbies fledged three young but none returned in 2012 :-(
2015 One Pair of subbies came and stayed a few nits but got chased away by Bluebirds and Tree swallows. :-(
2017 0ne pair of subbies nested and fledged 4 young
2018 Tree Swallows AGAIN chased away any martins that wanted to nest :evil:
2019 Same old story................ :-(
Guest

Money is an issue for me, after the cost of the house and pole. KathyF told me to use a 4' length of 6" PVC pipe on the base of the pole. I got my pipe cut to a 5' length at Lowe's and installed it. Total cost including the cap was about $10. And if I can do it, you can too!
Guest

I have a BB house that is only about 4'6" tall and always has a pair. I have pole guards on my martin houses but nothing on that bb pole. It is too low for a std. guard isn't it? I'm afraid to put netting right under the house for fear the bb's would become intangled. Ideas?
Louise Chambers
Site Admin
Posts: 6208
Joined: Tue Nov 04, 2003 1:07 pm
Location: Corpus Christi, TX

If you raised it up a bit, maybe another 6-8 inches, you could get a guard under it. A homemade PVC guard could be installed below it, either a 2 ft wobbly pvc pipe 6 inches in diameter, or a piece of PVC that runs right down to the ground, with the top capped off so a bird couldn't get down inside it. Installing netting would be risky - a bird could get caught with the netting so close to the nestbox.

Try to get a guard on it if you can, even though it's not perfect, it could help. Commercial raccoon guards I've used under bird feeders specified placing the guard so the top was 4 ft above the ground, no less. They worked beautifully for me - raccoons had been getting into the feeder, taking suet cages away, etc, and the guards at that height put a stop to it.

Louise
marshainpuntagorda
Posts: 177
Joined: Mon Jan 12, 2004 7:58 pm
Location: Punta Gorda/Florida

I understand the cost of everything is going up each day...I've had my equipment for years, but that was even expensive then for us and had to get them a bit at a time...if you can't get a pole guard for snakes, maybe the bird netting would help? Just a suggestion...I've donated bird netting to my neighbors for their housing, maybe you could find another landlord to share the expense of the netting...wishing the best of luck with your site, everyone!!!
Marsha
Think Purple!
Julio
Posts: 876
Joined: Wed Mar 07, 2007 8:37 am
Location: Pembroke Pines, FL

Will 4" PVC Pipe Schedule 40 work? I have a 4.5' section with a cap and im wondering if it will work to deter snakes raccoons and squirrels, from my Woodpecker house.My lowes does not carry 6" PVC pipe :roll:
"We can judge the heart of man by his treatment of animals." - Immanual Kant.

https://plus.google.com/u/0/+JulioPrado954/posts
Louise Chambers
Site Admin
Posts: 6208
Joined: Tue Nov 04, 2003 1:07 pm
Location: Corpus Christi, TX

Julio,

Sorry your question did not get an answer. 4 inch PVC will not stop snakes or raccoons. It's a good time to resurrect this thread anyway, we have lots of new Forum members. We hope everyone who gets martins (or bluebirds, tree swallows, etc) will use pole guards.

Louise
Guest

I put up close to 40 wood duck boxes, 35 warbler boxes and 25 bluebird boxes this year and every one of them had a guard to go with it. If it wasn't a cone guard, it was a piece of flashing wrapped around the pole beneath the box. Now I've got 5 martin poles and none of them have guards, but I keep saying everyday that I'm going to use the left over cone guards in my shop on the martin poles. It's time to do it before it's too late.

You can make a cone guard out of a piece of flashing and it's pretty simple. Attach with nails to wooden poles or use a big hose clamp on a metal pole. http://www.woodducksociety.com/Cone.pdf
KathyF
Posts: 3522
Joined: Thu May 24, 2007 1:57 pm
Location: Missouri/Licking
Martin Colony History: Colony started - 2007 with one pair
As of 2018 - 84 cavities offered, max # of pairs hosted - 82.

Louise,
I now have my new Trendsetter & pole w/ winch setup. There's no way to get more than about a 28-30" length of 6" pvc pipe under that winch. I read that you recommend leaving it "wobbly" (ie, no cap) if the length is shorter than 4', is that correct? Is there any risks associated with leaving the cap off?

I'm going to put on snake netting also, so I'm guessing I should just route the cable through the netting above the winch?

Thanks!
"Sometimes", said Pooh, "the smallest things take up the most room in your heart."
2023 - 82 pair
2022 - 80 pair
2021 - 75 pair
2020 - 78 pair
2019 - 80 pair
http://kathyfreeze.blogspot.com
Louise Chambers
Site Admin
Posts: 6208
Joined: Tue Nov 04, 2003 1:07 pm
Location: Corpus Christi, TX

hi Kathy -

From the reading I've been doing, wobbly is better than stationary for smaller size pipes and shorter lengths. Leaving the cap off the top of the guard, if that's what you're asking, would not be a good idea - it would allow snakes to go straight up. Granted, you'll have a net trap above it but wouldn't you rather any snakes get stopped by the PVC before they get into the net? The cable should go flat against the pole, underneath any mounting hardware for guards or net traps. I hope that makes sense...

Louise
Last edited by Louise Chambers on Thu Mar 06, 2014 5:43 pm, edited 1 time in total.
Post Reply